Shearing machine safety operation procedures and introduction
The shearing machine is a moving blade and a fixed lower blade. With a reasonable blade gap, shearing force is applied to the metal plates of various thicknesses to break the plates according to the required size.
The working principle of the shearing machine and the structural shearing machine are commonly used to cut the blank of the sheet at the edge of the straight line. The shearing process should ensure the linearity and parallelism of the sheared surface of the sheared sheet and minimize the distortion of the sheet to obtain a high quality workpiece.
Shearing machine is one of the forging machinery, the main role is the metal processing industry.
Products are widely used in: light industry, aviation, shipbuilding, metallurgy, instrumentation, electrical appliances, stainless steel products, steel structure construction and decoration industry
Shearing machine safety operation procedures:
1. Wear tight protective clothing before operation, fasten the cuffs, and the hem of the top should not be open. Do not wear or change clothes around the machine, or cloth around the body to prevent the machine from being wounded. A safety helmet must be worn, and the tweezers should be placed in the cap. Do not wear skirts or slippers.
2. The machine operator must be familiar with the main structure, performance and usage of the shearing machine.
3. This machine is suitable for all kinds of steel plates, copper plates, aluminum plates and non-metal materials with shearing material thicknesses. It must be no hard marks, welding slag, slag inclusions, welds. .
4. How to use this machine:
a. Adjust the gap of the blade according to the thickness of the material to be cut.
b. Adjust the master or fixture according to the width of the material being cut.
C. Make 1 to 3 empty strokes before the machine is operated. The cutting work can be carried out after normal operation.
5. If the machine is not working properly during use, the power supply shutdown should be cut off immediately.
6. When adjusting the machine tool, the power must be cut off. When moving the workpiece, pay attention to the safety of the hand.
7. All parts of the machine tool should be kept lubricated frequently. The oil should be filled by the operator once every shift. The mechanics should fill the rolling bearing parts once every six months.
Concerned about surprises
Label: Shearing machine safety operation procedures and introduction
Previous: Home improvement hardware installation steps Next: Furniture hardware building materials market traps more savvy purchase is not
Drainboard sinks are sinks that have an attached drainboard usually on one side but sometimes on both sides. This drainboard is grooved and slightly angled down so that water drains directly into the sink while dishes are resting on it. It is a kitchen accessory that helps you to dry your dishes.
Drainboard Sink,Cast Iron Sink With Drainboard,Washboard Sink,Double Bowl Sink With Drainboard
JIANGMEN MEIAO KITCHEN AND BATH CO.,LTD , https://www.meiaogroups.com