Outer cone face cutter
For hexagonal lathes such as C365L and CB3450, the hexagonal tool holder cannot be conical. With the aid of this tool holder, the outer conical surface of the car can be used. The tool holder (see picture) is used by our factory for the original iron cow? The rear wheel hub sleeve of the tractor has been used for many years. Use four M18 fastening screws to fasten the shank to the turret, with a center height of φ70 mm cylindrical shank. The pin 11 is a pivot of the tool holder (?), the tool holder 1 is loaded with a turning tool, and the bearing 7 is mounted at one end. The compression spring 6 forces the bearing 7 against the template and is clamped to the square tool holder by the template. When turning, the square knife holder does not move and is fixed by the template. When the turret turret moves toward the headstock, the turning tool is opposite to the slanting direction of the stencil, and the bevel angle is equivalent to 1/2 of the slant angle of the template (the lever ratio is 60:
Pro Roller Frame,Roller Handle,Soft Handle Roller Frame,Any Color Soft Handle Roller Frame
Ningbo Beilun Gelei Plastic Parts Co.,Ltd , https://www.paintwelltools.com