Fault Analysis and Treatment of Motor Overheating in Gear Oil Pump

Gear pump is mainly used in oil, chemical, metallurgy, mining, power plants and other industries of oil media transfer, pressurization, fuel injection, and large oil and thin oil machinery and equipment circulation, in all types of machinery and equipment can do lubrication pump use. Motor overheating gear pump is often in the course of the work of the problem, the specific analysis and testing are as follows: 1. The use of the scope (flow, lift) than the gear pump design requirements? Select the appropriate type of motor spectrum 2. The proportion of the medium over the gear pump configuration motor? Configure the appropriate gear motor oil pump 3. packing gland pressure is too tight or mechanical seal spring is too tight? Re-adjust the gland or mechanical seal spring compression 4. Pump assembly quality is poor, there is friction or motor and pump shaft is not the same? Check the assembly quality, eliminate assembly problems? For the above conditions, one by one to do the analysis to find out the real cause of motor overheating, in accordance with the corresponding fault, maintenance treatment.