Asphalt insulation pump precautions

Note the use of asphalt heat pump: 1. Asphalt heat pump must be determined before turning on the direction of operation, shall not be reversed. 2. Asphalt heat pump is strictly prohibited in the case of no air to run, so as not to damage the stator. 3. The new G-type single screw pump installed or shut down after a few days, can not be started immediately, should be poured into the asphalt heat pump body appropriate amount of oil, and then a few turns after the tube nipper can be started. 4 transport high viscosity or containing particles and corrosive media, the application of water or dissolved rinse to prevent clogging, so as not to start the next difficulty. 5. Winter should line up fluid to prevent cracking. 6 asphalt insulation pump bearing box should be used during the regular addition of lubricating oil and found that the shaft end of the seepage, it is necessary to promptly handle or replace the oil seal. 7. In the event of anomalies, stop immediately to check the cause and eliminate the fault. Asphalt heat pump in use in accordance with certain methods and principles of production and use, to ensure that production practices can produce good value and contribution to the industry to show good development and status, to adapt to the development needs of the industry.

Steel Coil/ Steel Rolls/Steel Strip

Huilifeng Anti-Corrosion And Insulation Steel Pipe Group Co., Ltd , http://www.tj-steeltube.com