Wallpaper yin and yang angle processing method wallpaper yin and yang angle processing
The utilization rate of wallpaper is getting higher and higher. When the wallpaper is pasted in every room, the treatment of Yin Yang angle is not annoying for those who have no experience in decoration. After all, the poor handling will affect the later period. Use and aesthetic effects. So, today Xiao Bian tells everyone, what are the methods of wallpapering the yin and yang angles ? This is absolutely beautiful and practical. 
Wallpaper angle of Yin Yang angle treatment method
1. First, you should use a scraper to carefully put the wallpaper on the wallpaper, and across the convex corner, but remember that you can't stick to another wall at this time.
2. Make a fold from the top to the bottom of the convex corner by hand, and then draw a vertical line from the ceiling to the floor at a position 2.5cm from the raised wall.
3. Next, use the utility knife to cut the wallpaper along the vertical line in the previous step. Remember to use a ruler to assist.
4. If you have the rest of the wallpaper, you should also carefully save it for later use.
5. Use the seam pressure wheel to level out the overhanging wallpaper. Add glue on the wallpaper.
6. Pick up the wallpaper attached to the cover. The graphics are spliced. Scrape the wallpaper with a scraper and press it down with a roller. 
Treatment of the internal corners of houses without settlement
1. Measure from the center of the last wallpaper to the corner of the concave wall, then add 2.5cm. Cut out a piece of wallpaper with this width.
2. Paste the previous cropped wallpaper, align it and attach the last attached wallpaper and level it in the corner of the recess.
3. Use a scraper to scrape up and down, let the overhang stick to the wall, and dry the glue on the scraper.
4. At the outer corner of the reentrant, measure the width of this section and add 5mm. Then mark the wall.
5. Place a spirit level at the mark you made above to check if it is truly horizontal and vertical, and apply glue on the covered wallpaper.
6. Align the outer side of the covered wallpaper with the vertical line, and the vertical line will prevail. Paste the remaining wallpaper in the room. 
House settlement settlement of the internal angle
1. Paste another wallpaper with the previous wallpaper. Remember to align the wallpaper and turn to the other wall.
2. Use the back of the squeegee to flatten the inside corner in the position of the inside corner. First of all, slowly put the wallpaper close to the inside corner, and then use the back of the scraper to slowly flatten the inside corner, do not use force to avoid hurting the wallpaper.
3. At a distance of 2mm from the inside corner, the scraper is repaired with a crease. Use a ruler with a utility knife to cut it from top to bottom.
4. Remove excess wallpaper and use a white towel or sponge to wipe off excess glue. 
Edit Summary: The above is small series on wallpaper paste yin and yang angle processing method, introduced wallpaper paste this yin and yang angle processing it. After reading this article, do you have a certain understanding of the method of wallpapering the yin and yang angles ? Do you still have doubts about yin and yang angle wallpaper processing?
Mineral Thickener,High Rate Thickener,Thickener For Mineral,Mineral Processing Thickener
Shanghai Na Long Tech Co., Ltd , https://www.na-long.com