Technology - FAG Bearing Removal and Installation New Tips

The FAG bearing is a very precise structural bearing device and the disassembly must be cautious. The <FAG bearing is a very precise structural bearing device and disassembly must be discreet. A slight oversight can cause bearing damage so care must be taken when installing the device especially when removing FAG bearings to remove a skill

It can be closed at the same time it should pay attention to the internal acceptance of tension FA G bearing inner ring to remove large-scale hydraulic method is best to use the device on the shaft oil through the oil hole in order to facilitate drawing FA G bearing oil injection joint drawing fixture width assembly operation NU type inner ring NJ type cylindrical roller bearings can be assembled by inductively heating a locally heated inner ring for a short period of time and then drawing the inner ring assembly of a cylindrical bore bearing assembled first with the press method. >
The outer ring assembly assembly bearing interference fit outer ring outer ring arranged in advance several pairs of screw extruder shell circumference, followed by. Use the same screws to fasten the screws to eliminate the screw holes. Usually include blind plugs. Separate FAG bearings Tapered roller bearing housings Place several cutouts on the shoulders. Use the pad to remove or gently tap the assembly. The assembly of bearings for bearing bore bearings of small bearings removes the tight FAG bearing sleeves, and finally. After the bearing seat has tightened the support inner ring nut several times, use a hammer to remove the large FAG bearing with a pad. Hydraulic assembly and disassembly is easy for the pressurized oil cone shaft oil hole to expand the inner ring. FA G bearing assembly method Operation, FA G It may be better to use the nut as a stopper when the bearing suddenly comes out.

LED Sensor Batten Lights

Led Sensor Batten Lights has options of microwave sensor and infrared sensor. There are two sensing modes. One is 0-10v dimming, and the other is on/off.

The main difference between these two modes is that the 0-10v dimming mode can set the brightness of the light after the person walks, and the pending time of this brightness can also be set. On/off mode, you can only set the time for the lights to turn off after a person walks, but not the brightness (that is, functions 3, 4 cannot be implemented). The 0-10v dimming mode is more intelligent.

Briefly introduce the function of sensor light:

1. Set up daylight threshold: If the ambient light is higher than the set brightness, the sensing function will not be triggered.

2. Set up the hold time: The time for the light to maintain brightness after the person walks away.

3. Set up a stand-by dim level: set the brightness maintained after the person walks

4. Set up stand-by time: After the person walks, the time to maintain low brightness

5. Set up detection area: Set the detection area.

Toggle button can set the remote distance of remote control and sensor.

If you need sensor lights in factories or warehouses, corridors, or other indoors, you can choose this LED Sensor batten lights. If you need IP66 sensor light, you can choose Sensor Waterproof Light.

Motion Sensor Led Light,Sensor Led Light,Motion Sensor with Led Light,Led Light Motion Sensor

SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.szlitehomelight.com