The latest paving method Paving tiles method considerations
Floor tiles are the home improvement materials that every home improvement needs. In addition to the selection of cost-effective, environmentally-friendly floor tiles, the paving method is also very important, which determines whether the floor tiles are better cleaned in the later period and the service life of the floor tiles. So, today, Xiao Bian has come to introduce the latest paving methods for you, and you can learn about the precautions of the bunker tiles. 
First, the latest paving method
1, tile soak
First clean up the purchased tiles and soak them for at least 2 hours. The purpose of soaking is to make the tiles more fully absorb moisture. After the tile is fully immersed in water, it must be wiped off the water on the tile surface before the paving begins.
2, set the auxiliary line
Before starting to lay the tiles, you need to hung a vertical line on the wall screed to determine the line size of the tiles. Then set the horizontal line. The purpose is to keep the tiles horizontal and vertical and smooth. . 
3, set the support board
When laying tiles, be sure to use a horizontal line as the guide and set a board that can support the tiles. The purpose of this is to prevent the tiles from displacing or falling before reaching the adhesion strength.
4, according to the order posted
Tiles are generally laid out by the edge of the door (or balcony), from top to bottom, from left to right.
5, cleaning and maintenance
The stains and dust on the surface after the floor tile is finished need to be cleaned in time. Here are some methods for cleaning and maintenance. 
Second, the latest paving method should pay attention to what
1, the kitchen and toilet In order to facilitate drainage, the ground must have a slope.
2, when paving the floor tiles, we must pay attention to the treatment of the waterproof layer. The kitchen and bathroom require special attention when it comes to waterproofing. Because if the waterproof does not come out well, if you need to replace the floor tiles later, it will damage the original waterproof layer of cement mortar, so it is recommended before the paving tiles, can be a layer of asphalt waterproof layer, the gap between the tiles filled with white cement.
3, brick surface to be flat, the angle should be accurate, the interface to the line, the tile soaked in water for half a day before use. Different areas of the floor tiles, the choice of material should also be different, for example, the best choice for living room floor tiles tiles, because it is wear-resistant, bright, easy to clean. 
Editor's summary: The above is the introduction of Xiaobian 's approach to the latest paving tiles and the precautions for paving tiles. After reading this article, did you have the latest methods for mastering the Pudi tiles? Whether or not the floor tiles are in place is very important for the later use and care, so everyone must master the correct paving method.
Tubular waterproof lights are waterproof, corrosion-proof and dust-proof. The respirator design quickly balances the pressure difference between the inside and outside of the lamp to prevent water and dust from entering the inside of the lamp to ensure the normal operation of the lamp.
Compared with the traditional waterproof lamp, it is more convenient to install. It only needs to open the orange end cap of the Led Tube Light, thread the wires in, and connect the terminals.
Led Tube Light can not only be linkable in series but also Parallel Connection, as shown in the figure below.
There are two installation methods, one is a sling and the other is ceiling installation. There are two types of ceiling installations, one is fixed and cannot be moved, and the other can be rotated 180°.
IP66 LED Tri-proof Light has emergency and sensing functions, which is very suitable for parking lots, warehouses, basements, workshops, etc.
Ip66 Tube Light,Waterproof Led Light,Led Tube Light,Waterproof Outdoor Light
SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.szlitehomelight.com