Do not forget the bathroom must be waterproof moisture
Wall tiles and stone should be laid under the surface to make a waterproof layer. The cement mortar should be used to level the ground and apply waterproof coating. Afterwards, a layer of cement mortar of 1 to 2 should be used as a bonding layer to adorn the tiles and other decorative materials. After being watered, it is tamped with wooden boards to achieve a firm and tight joint. Before stone paving, back-coating should be done to reduce the phenomenon of “water stainsâ€. The contact area of ​​the waterproof layer with the wall should be turned upwards, about 25 to 30 cm above the ground, and the wash cabinet should be 1.0 to 1.2 meters above the ground, and the shower should be 1.8 meters above the ground. If you do paint decoration should first brush waterproof putty and use waterproof coating. The ground surface layer of flowing water should be drained to the ground, and the pan and water should not fall. After 24 hours of storage test, there is no leakage.
Ceilings are recommended to use microporous aluminum gussets to enhance ventilation and prevent condensation. If you do plasterboard ceiling, you should first brush waterproof putty, and then brush waterproof coating; PVC ceiling is easy to produce condensation, and drop, should be used with caution.
Pipeline installation to avoid changing the original up and down the pipe, must be horizontal and vertical decoration, laying a firm, slope meet the requirements. Valves, faucets are installed with a flat surface, flexible and easy to use, bright tube brush anti-rust paint, dark pipe brush anti-corrosion paint. The water supply pipe is closely connected with accessories and appliances, and there is no leakage through the water test. Floor drain design is still based on the above drainage pipeline, and the surface should be slightly lower than the ground.
The sanitary appliance is installed in the correct position and the appliance has to be level on its top edge. Bathroom appliances should be branded and have better waterproof performance. For example, shower warm lamps that are used in wet environments for a long time should be made of stainless steel. The anti-corrosion performance is better. Also, waterproof power switches, cables, and plugs are used. When it is powered off, it is not afraid of water showering or water splashing. It will not cause leakage or damage. Need to be equipped with waterproof shades, waterproof sockets and so on.
Living room ceiling aisle ceiling paint bathroom cement home paint decoration home
An infrared sauna room is a type of sauna that uses infrared heaters to emit radiant heat, which is then absorbed by the body. Unlike traditional saunas that heat the air around you, infrared saunas directly heat your body, allowing for a more efficient and comfortable experience.
The infrared heaters in the sauna emit infrared radiation, which is the same type of heat that is produced by the sun. This heat penetrates deep into the body, promoting relaxation, detoxification, and various health benefits. The temperature in an infrared sauna room is typically lower than in a traditional sauna, making it more tolerable for longer sessions.
Apart from the physical benefits, sauna rooms are often used for relaxation and stress relief. The heat and steam create a soothing environment that can help calm the mind and reduce anxiety. Sauna sessions can also promote better sleep and improve overall mood.
Infrared Sauna Room,Far Infrared Sauna Room,Indoor Far Infrared Room,Infrared Dry Sauna
Foshan Nanhai Halo Sanitary Ware Co., Ltd. , https://www.halotub.com