Composite floor installation process laying laminate flooring should pay attention to what
More and more consumers will choose composite flooring when purchasing floorboards. They not only have the characteristics of wear resistance and anti-corrosion, but also the most important thing is that the price is cheap. So what is the composite floor installation process ? What should I pay attention to when laying? The following Xiao Bian took everyone to learn about it!
1 , composite floor installation process - primary treatment
Before the installation of the composite floor, the construction area should be cleaned and the base surface leveled. Ground level error can not exceed 2mm, otherwise the floor even if the foot feel is very poor.
2, composite floor installation process - laying cushion
Wait until the base level is clean and clean, and then apply a moisture barrier so that the floor can be protected from moisture deformation. Note that the moisture barrier should be laid flat and the seams should be close together.
3, composite floor installation process - trial pre-arrangement
The floor should be pre-paved before paving. You can saw parts of the floor according to the size. Do not use a good floor to saw it. It will increase more losses. It is possible to open all the floors and find the floorboards to be sawed. At the same time, the floor will have a certain expansion rate. Therefore, it is necessary to reserve expansion joints to prevent the floor from kicking.
4, composite flooring installation process - wood flooring
Then formally enter the laying of the floor, and it is best to a short side next to a long floor, so that the staggered floor to make the floor more difficult to loose together. Next, it is necessary to install a bead. The floor height is high and low pressure, and the floor is flat with the floor.
5, composite floor installation process - installation skirting board
After checking the floor, it will be repaired in an imperfect place, and it will enter the next step to install the skirting board. When installing, the joints should be tight and flush. Also make sure that you can hold down the floor wall seams. When these are done, cleaning up the surface will be completed.
What to pay attention to laying laminate flooring :
1. If the floor on which the laminate flooring is installed is not flat, it will need to be leveled again with cement. It is not until the floor dries up and it can be used for the next process. Generally, the new concrete floor can be installed in three days.
2. If the indoor walls are too wet, it is not possible to install a skirting board. For a friend who changes the floor of a second-hand house, you can destroy the previous baseboard and use cement to trim the walls and corners. When laying the floor, keep the interface between the board and the board tight and flush, and also need to be wrong, and leave some gaps from the door frame.
Conclusion: The above is the introduction of the flooring installation process and the related precautions when it comes to paving, hoping to bring help to friends in need. There are many precautions when installing the laminate flooring. I hope you can learn more about it in advance. If you need to learn more about the relevant information in the later period, you are welcome to pay attention to Qijia Information.
Alloy Cast Ball,Wear-Resistant Chrome Steel Ball,Ore Grinding Abrasion-Resistant Steel Ball,Steel Ball For Ore Grinding
Xuzhou Surun wear-resistant material Co., LTD , https://www.suruntools.com